This is a DJI Pocket 2 with the DJI Pocket 2 Do-It-All Handle GoPro Mount I designed. I couldn’t easily find one that adapted to the DJI Pocket 2 Do-It-All Handle. I didn’t like the tolerances for the ones I found that were just for the DJI Pocket 2.
I designed this using Shapr3D. It was printed using PETG filament. Yes I know it’s white. I might paint it later after some sanding.
It’s funny. I normally end up making something from scratch. I can never find exactly what I’m looking for off the shelf. That applies to software, hardware, furniture, camping gear, and mostly everything on the market outside of the kitchen. There are worse problems to have.
Below I’ve included the Thingiverse link where I provided the STL file if you want to print it yourself. Since this is an older DJI product I’m probably not going to iterate the design much more than this. Enjoy!
Leave a Reply